TRB POWER support
Use these guides before installing TRB POWER batteries, controllers, motors, and performance upgrade kits for electric dirt bikes and e-moto builds. If your build has custom wiring or non-standard parts, contact us before powering the system on.
Disconnect the battery before working on the bike. Inspect every connector, cable, fuse, and mounting point before powering the system on. If you are not experienced with high-output electric systems, use a qualified technician.
Check your electric dirt bike model, battery voltage, controller rating, connector type, mounting space, and required firmware or app settings before installation.
Turn the vehicle off, remove the key, disconnect the original battery, and secure the electric dirt bike on a stand. Keep tools away from exposed terminals.
Mount the component without forcing it into the frame. Route cables away from moving parts, sharp edges, heat, and suspension travel.
Verify positive and negative polarity before connecting power. Make sure every signal plug, phase wire, and main power connector is fully seated.
Power on with the rear wheel off the ground. Check for error codes, abnormal heat, unusual sounds, throttle response, and brake cut-off behavior.
Start with low power settings. Test throttle response, braking, regen behavior, and temperature before riding at full output.
Send us your electric dirt bike model, battery voltage, controller model, motor model, photos of your connectors, and your target riding style. We will help confirm the correct setup.
